HPE FlexNetwork MSR3012 User Manual

188
Table 43 Standard SNMP notifications
Keyword
Definition
authentication
Authentication failure notification sent when an NMS fails to authenticate to the
SNMP agent.
coldstart
Notification sent when the device restarts.
linkdown
Notification sent when the link of a port goes down.
linkup
Notification sent when the link of a port comes up.
warmstart
Notification sent when the SNMP agent restarts.
system: Specifies system notifications sent when the system time is modified, the system reboots,
or the main system software image is not available.
Usage guidelines
The snmp-agent trap enable command enables the device to generate notifications, including both
informs and traps, even though the keyword trap is used in this command.
You can use the snmp-agent target-host command to enable the device to send the notifications as
informs or traps to a host.
If no optional parameters are specified, this command or its undo form enables or disables all SNMP
notifications supported by the device.
Examples
# Enable the SNMP agent to send SNMP authentication failure traps to 10.1.1.1 in the community
public.
<Sysname> system-view
[Sysname] snmp-agent target-host trap address udp-domain 10.1.1.1 params securityname
public
[Sysname] snmp-agent trap enable standard authentication
Related commands
snmp-agent target-host
snmp-agent trap if-mib link extended
Use snmp-agent trap if-mib link extended to configure the SNMP agent to send extended
linkUp/linkDown notifications.
Use undo snmp-agent trap if-mib link extended to restore the default.
Syntax
snmp-agent trap if-mib link extended
undo snmp-agent trap if-mib link extended
Default
The SNMP agent sends standard linkUp/linkDown notifications.
Views
System view
Predefined user roles
network-admin

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English