HPE FlexNetwork MSR3012 User Manual

147
poe priority (system view)
Use poe priority to set the power supply priority for a PSE.
Use undo poe priority to restore the default.
Syntax
poe priority { critical | high | low } pse pse-id
undo poe priority pse pse-id
Default
The power supply priority of a PSE is low.
Views
System view
Predefined user roles
network-admin
Parameters
critical: Sets the power supply priority to critical. The PSE with critical power priority operates in
guaranteed mode, and power is supplied to it first.
high: Sets the power supply priority to high.
low: Sets the power supply priority to low.
pse pse-id: Specifies a PSE by its ID.
Usage guidelines
If PSE power management is disabled, the system does not supply power to new PSEs when PoE
power overload occurs.
If PSE power management is enabled, when PSE power overload occurs, the system supplies
power to a PSE with higher priority. For multiple PSEs with the same priority, the PSE with a smaller
ID gets power supplied first.
For example, if PoE is enabled for a PSE, and the PSE has higher priority, the system performs the
following operations:
•
Stops supplying power to a PSE with lower priority.
•
Supplies power to the PSE that has higher priority.
Examples
# Set the power supply priority of PSE 7 to critical.
<Sysname> system-view
[Sysname] poe priority critical pse 7
Related commands
poe pse-policy priority
poe pse-policy priority
Use poe pse-policy priority to enable PSE power management.
Use undo poe pse-policy priority to disable PSE power management.
Syntax
poe pse-policy priority

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English

Summary

Ping, tracert, and system debugging commands

ping

Tests reachability of destination IP address and displays ping statistics.

tracert

NQA commands

NQA client commands

Configures NQA client operations, including factors, codec types, and data parameters.

NTP commands

SNTP commands

PoE commands

apply poe-profile

Applies a PoE profile to a power interface (PI).

SNMP commands

display snmp-agent community

Displays SNMPv1 or SNMPv2c community information.

snmp-agent community

Configures an SNMPv1 or SNMPv2c community.

snmp-agent target-host

Configures an SNMP notification target host.

snmp-agent trap enable

Enables SNMP notifications.

RMON commands

display rmon alarm

Displays information about RMON alarm entries.

rmon alarm

Event MIB commands

NETCONF commands

CWMP commands

cwmp enable

Enables CWMP.

EAA commands

action cli

Adds a CLI action to a monitor policy.

rtm cli-policy

Creates a CLI-defined EAA monitor policy and binds it to a Tcl script file.

Process monitoring and maintenance commands

display exception context

Displays context information for process exceptions.

display kernel deadloop

Displays kernel thread deadloop information.

display process

Displays process state information.

monitor kernel starvation enable

Enables kernel thread starvation detection.

Port mirroring commands

mirroring-group

Creates a mirroring group.

Flow mirroring commands

mirror-to

NetStream configuration commands

IPv6 NetStream commands

sFlow commands

Information center commands