HPE FlexNetwork MSR3012 User Manual

183
Views
System view
Predefined user roles
network-admin
Parameters
inform: Specifies informs.
trap: Specifies traps.
interface-type { interface-number | interface-number.subnumber }: Specifies an interface by its type
and number. The interface-number argument specifies a main interface number. The subnumber
argument specifies a subinterface number in the range of 1 to 4094.
Usage guidelines
The snmp-agent source command enables the SNMP agent to use the primary IP address of an
interface or subinterface as the source IP address in all its SNMP informs or traps, regardless of their
outgoing interfaces. An NMS can use this IP address to filter all the informs or traps sent by the
SNMP agent.
Make sure the specified interface has been created and assigned a valid IP address. The
configuration will fail if the interface has not been created and will take effect only after a valid IP
address is assigned to the specified interface.
Examples
# Configure the primary IP address of GigabitEthernet 1/0/1 as the source address of SNMP traps.
<Sysname> system-view
[Sysname] snmp-agent trap source gigabitethernet 1/0/1
# Configure the primary IP address of GigabitEthernet 1/0/2 as the source address of SNMP informs.
<Sysname> system-view
[Sysname] snmp-agent inform source gigabitethernet 1/0/2
Related commands
snmp-agent target-host
snmp-agent trap enable
snmp-agent sys-info contact
Use snmp-agent sys-info contact to configure the system contact.
Use undo snmp-agent sys-info contact to restore the default contact.
Syntax
snmp-agent sys-info contact sys-contact
undo snmp-agent sys-info contact
Default
The system contact is Hewlett Packard Enterprise Development LP..
Views
System view
Predefined user roles
network-admin

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English