■ Calling a specic station
This section describes how to call a specific station
using the DR mode.
When the Link repeater (R2) is set to “GW,” the des-
ignated gateway repeater is automatically set as the
Link repeater, and you can make a call to a specific
station through the internet.
q Set your own call sign.
w Hold down [DV•DR] for 1 second to select the DR
mode.
•The last used access repeater is displayed.
- If the displayed frequency band on the SUB Band is
the same as that of the last used access repeater, se-
lecting the DR mode on the MAIN Band will automati-
cally move the frequency band on the SUB Band to
the Main Band display, and turn OFF the SUB Band
display.
e Rotate [MAIN DIAL] to select the desired access
repeater.
•Onlytherepeaters, whose “R1USE” setting is set to
YES,orAccessrepeaterscantargets are displayed.
(pp. 90, 100)
r Push [UR](F-4) to enter the UR call sign selection
mode.
t Rotate [MAIN DIAL] to select a individual station
call sign.
•First selecting the station call sign memory groups
(U01–U99)bypushing[TS•GRP]makesitmoreconve-
nient.
y Hold down [UR](F-4) for 1 second to enter the Link/
Gateway repeater (R2) selection mode.
Making a call to an individual station through your
local area (access) repeater (Local Area call)
MY call sign：
JA3YUA
Station call sign：
JG3YMK
Repeater q ： NARA43
(JP3YHL)
q w e r
Area
Zone
u Rotate [MAIN DIAL] to select “NOT USE✱.”
i Push [UR](F-4) to exit the Link repeater (R2) selec-
tion mode.
o Push [PTT] on the microphone to transmit. (or
[TRANSMIT] on the transceiver)
•TheMAINBandTX/RXindicatorlightsred.
!0 Release [PTT] to receive. (or push [TRANSMIT]
again)
If you want to save this temporary setting, push [MW]
to enter the memory select write mode. (p. 102)
[MAIN DIAL]
[DV•DR]
[TS•GRP][UR]
NOT USE✱
CS CD R>CS UR DSET
D1
R2:NOT USE�
[TRANSMIT] [UR] [MW]
[MAIN DIAL]
MAIN Band TX/RX indicator
To Next Page
Loading...
Need help?
General
