Kubota M6040 NARROW - Check Points of Every 600 Hours; Check Point of Every 800 Hours; Check Point of Every 1500 Hours

GENERAL
M6040, M7040Narrow, WSM
NG-32
[8] CHECK POINTS OF EVERY 600 HOURS
Replacing Engine Oil Filter
1. Refer to "[2] CHECK POINTS OF INITIAL 50 HOURS" in this
section.
9Y1210220GEG0041US0
Changing Transmission Fluid
1. Refer to "[2] CHECK POINTS OF INITIAL 50 HOURS" in this
section.
9Y1210220GEG0042US0
Changing Front Differential Case Oil
1. Refer to "[2] CHECK POINTS OF INITIAL 50 HOURS" in this
section.
9Y1210220GEG0043US0
Changing Front Axle Gear Case Oil
1. Refer to "[2] CHECK POINTS OF INITIAL 50 HOURS" in this
section.
9Y1210220GEG0044US0
Adjusting Front Axle Pivot
1. If the front axle pivot pin adjustment is not correct, front wheel
vibration can occur causing vibration in the steering wheel.
 Adjusting Procedure
1. Loosen the lock nut (1), screw in the adjusting screw (2) until
seated, then tighten the screw (2) with an additional 1/6 turn.
Then tighten the lock nut (1).
9Y1210220GEG0045US0
[9] CHECK POINT OF EVERY 800 HOURS
Adjusting Engine Valve Clearance
1. Refer to "[1] CHECKING AND ADJUSTING" at "1. ENGINE"
section.
9Y1210220GEG0046US0
[10] CHECK POINT OF EVERY 1500 HOURS
Checking Fuel Injection Nozzle (Injection Pressure)
1. Refer to "[1] CHECKING AND ADJUSTING" at "1. ENGINE"
section.
9Y1210220GEG0047US0
Tightening torque Lock nut
98.1 to 147.1 N·m
10.0 to 15.0 kgf·m
72.3 to 108.5 lbf·ft
(1) Lock Nut (2) Adjusting Screw
KiSC issued 07, 2012 A