Lenze ECS series User Manual

Commissioning
Commissioning steps (overview)
6

103
EDBCSXA064 EN 3.2
6.2 Commissioning steps (overview)
Start
Create a new project with the Drive PLC Developer
Studio (DDS) and load it into the ECSxA... axis module
 DDS Manuals:
– Introduction in the IEC 61131−3 programming
– Getting started
– Reference Manual
Make the basic settings using the parameter setting
program Global Drive Control (GDC).
( 104)
l Switch on the mains.
l Enable controller ( 141).
l Save parameters in the controller with C0003 = 1.
l Save parameter set with GDC in the parameter set
file.
Optimise
drive behaviour
( 141)
l Save parameters in the controller with C0003 = 1.
l Save parameter set with GDC in the parameter set
file.
End

Lenze ECS series Specifications

General

Brand	Lenze
Model	ECS series
Category	Control Unit
Language	English