Lenze ECS series User Manual

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Description of the display elements
7

151
EDBCSXA064 EN 3.2
7.3.2 Description of the display elements
YZ
y
z
T V
S U
dABbc
p
SHPRG
Para
Code
Menu
0050
00
50.00_Hz
MCTRL-NOUT
0
1
3
4
5
6
7
8
2
9371BC002
Fig. 7−2 Keypad front view

Status displays
Display Meaning Explanation
 Ready for operation
! Pulse inhibit active Power outputs inhibited
" Adjusted current limitation is exceeded in
motor mode or generator mode
# Speed controller 1 within its limitation l Drive is torque−controlled
l Only active for operation with Lenze
devices of the 9300 series!
$ Active fault

Parameter acceptance
Display Meaning Explanation
% Parameter is accepted immediately  The device immediately operates with the
new parameter value.
SHPRG % The parameter must be confirmed with 

The device operates with the new
parameter value after being confirmed.
SHPRG When the controller is inhibited, the
parameter must be confirmed with  
The device operates with the new
parameter value after the controller has
been released again.
None Display parameters Cannot be changed.

Active level
Display Meaning Explanation
Menu Active menu level l Selection of main menu and submenus
l No menu for ECSxE power supply
module
Code Active code level Selection of codes and subcodes
Para Active parameter level Change of parameters in the codes or
subcodes
None Active operating level Display of operating parameters

Short text
Display Meaning Explanation
Alphanumerical
Contents of the menus, meaning of the codes
and parameters
Display of C0004 in % and the active fault in
the operating level

Lenze ECS series Specifications

General

Brand	Lenze
Model	ECS series
Category	Control Unit
Language	English