12-22 Setup
12.2 Exam Related Preset
Select [Setup] -> [Presets] to enter the screen. You can assign exam modes for each probe or set
measurement, body mark and annotation settings for current exam mode.
12.2.1 Exam Mode Preset
You can assign available exam modes for probes.
1. Select the probe model in the drop-down list beside Probe column.
2. Check current configured exam modes:
On the left side, you can view all the available exam modes in the exam library for the probe.
On the right side, you can view the current exam modes assigned to the probe. (Tapping
[Probe] on the left side of the operating panel to see the list.)
3. Tap and hold any exam mode until it floats, then you can:
Drag the exam mode from “Library” column to “Selected” column to make the exam mode
available for the probe.
Drag the exam mode from “Selected” column to “Library” column to make the exam mode
unavailable for the probe.
4. Change default exam mode or delete user-defined exam mode if necessary:
To Next Page
Loading...
Need help?
General
