3-4 System Preparation
3.2.3 Standby
To enter standby:
Select [Setup] -> [System] -> [General] to set the time for screensaver and standby. If the
system is not carrying out an operation, the screensaver appears after the screensaver
delay period. If there is still no operation, the system enters standby after the standby
delay period.
Press the power button and select [Standby].
To exit standby:
Touch the screen lightly or press the power button.
Under the standby status:
Exit standby status and power off the system after 5s.
Power off the system if the system will not be used for a long period of time (including
storage/ transportation condition), and do not leave the system in standby status,
otherwise the batteries will run out of power and be permanently damaged.
If the system will not be used for a long period of time, you should disconnect the
power adapter, disconnect the mains power, and turn off the power to all peripherals
connected to the system.
To Next Page
Loading...
Need help?
General
