Exam Preparation 4-1
4 Exam Preparation
A patient exam can be started under the following situations:
New patient information: to start a new patient exam, patient information must first be entered.
New exam: to start a new exam for patient who is already registered, the recorded information
can be obtained through either iStation or Worklist. See chapter “4.1.2 Retrieve Patient
Information” for details.
Activate exam: to select an exam that has been completed within 24 hours, continue the exam
with imported patient information and exam data.
General procedure for an exam:
Enter the patient information –> select an exam mode and probe –> Choose an imaging mode ->
Start the exam.
Tips: The system supports image scanning and measurement without patient information.
4.1 Patient Information
To start a new patient exam, it is best to enter detailed patient information. The system will set up a
unique information database for each patient based on the patient information entered, so that the
information of one patient will not be confused with that of another patient.
Before examining a new patient, tap [End] in the bottom-left
corner of the operating panel to end the exam of the previous
patient. Update the patient ID and information to avoid mixing
data between patients.
To enter the Patient Info screen
Tap [Patient] on the left side of the operating panel.
To exit the Patient Info screen
Tap [Done] on the Patient Info screen.
Tap [Cancel] on the Patient Info screen to exit the screen without saving any of the entered
patient data.
To Next Page
Loading...
Need help?
General
