EasyManuals Logo
Home>NETGEAR>Switch>ProSafe XS728T

NETGEAR ProSafe XS728T User Manual

NETGEAR ProSafe XS728T
373 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #149 background imageLoading...
Page #149 background image
Configure Switching
149
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
10. In the Maximum Response Time field, set the value for the maximum response time of
MLD snooping.
The valid range is 1 to 20 seconds. The default value is 20 seconds. This value must be
shorter than the group membership interval value.
11. Click the Add button.
MLD snooping is enabled on the specified VLAN.
The Multicast Router Expiry Time field is a calculated field, displaying the value for the
multicast router expiration time of MLD snooping for the specified VLAN ID. This value is
calculated as the value in the Group Membership Interval field minus the value in the
Maximum Response Time field.
Configure a Multicast Router Interface on a VLAN
When you connect an external multicast router to a switch interface that is a member of a
VLAN and you configure that switch interface as a multicast router interface, the external
multicast router is automatically added to the list of learned multicast routers.
This dynamic learning mode is applicable only to multicast router information (that is, to
queries from an attached true querier). In such a situation, you do not need to enable a
snooping dynamic learning mode (that is, the snooping interface mode or the snooping VLAN
mode) for the multicast router interface.
 To configure a multicast router interface on a VLAN:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> Multicast > MLD Snooping > Multicast Router VLAN Configuration.

Table of Contents

Other manuals for NETGEAR ProSafe XS728T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR ProSafe XS728T and is the answer not in the manual?

NETGEAR ProSafe XS728T Specifications

General IconGeneral
BrandNETGEAR
ModelProSafe XS728T
CategorySwitch
LanguageEnglish

Related product manuals