NETGEAR ProSafe XS728T User Manual

Configure System Information
72
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
LLDP-MED Port Settings
Use this page to enable LLDP-MED mode on an interface and configure its properties.
 To configure LLDP-MED settings for a port:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select System > LLDP > Advanced > LLDP-MED Port Settings.
The LLDP-MED Port Settings page displays.
6. From the Port menu, select the port to configure.
7. Use the following menus to enable or disable the following LLDP-MED settings for the
selected port:
• LLDP-MED Status. The administrative status of LLDP-MED on the interface. When
LLDP-MED is enabled, the transmit and receive function of LLDP is effectively
enabled on the interface.
• Notification. When enabled, the port sends a topology change notification if a device
is connected or removed.
• Transmit Optional TLVs. When enabled, the port transmits the following optional
type length values (TLVs) in the LLDP PDU frames:
- MED Capabilities
- Location Identification
- Extended Power via MDI: PSE
- Extended Power via MDI: PD
- Inventory
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.

NETGEAR ProSafe XS728T Specifications

General

Brand	NETGEAR
Model	ProSafe XS728T
Category	Switch
Language	English