Configure Switching
151
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
6. Configure the following settings:
• Querier Admin Mode. Enable or disable MLD snooping for the switch. The default is
Disable.
• Snooping Querier Address. Enter an IPv6 address that is used as the source
address in periodic MLD queries. This address is used when no address is configured
on the VLAN on which a query is sent. The supported IPv6 address formats are
x:x:x:x:x:x:x:x and x::x.
• MLD Version. This is a field with the fixed value 1, which indicates that MLDv1 is the
version that is used in periodic MLD queries.
• Query Interval (secs). Specify the time interval in seconds between periodic queries
sent by the snooping querier. The query interval must be a value in the range of 30 to
1800. The default value is 125.
• Querier Expiry Interval (secs). This is a field with a calculated value that shows the
interval in seconds after which the last querier information is removed. The interval is
calculated as 2 * Query Interval + 5. The default value is 255.
7. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The VLAN IDs Enabled for MLD Snooping Querier section displays the IDs of the VLANs
for which MLD snooping querier is enabled (see Configure MLD Snooping Querier VLAN
Settings on page 151).
Configure MLD Snooping Querier VLAN Settings
 To configure MLD snooping querier VLAN settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
To Next Page
Loading...
Need help?
General