NETGEAR ProSafe XS728T User Manual

Configure Switching
150
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
6. From the Interface menu, select the multicast router interface.
This is the interface to which an external multicast router is connected.
7. From the VLAN ID menu, select the VLAN ID of which the interface must be a member.
8. From the Multicast Router menu, Enable or to enable the multicast router mode for the
VLAN (and therefore, for the multicast router interface).
By default, Disable is selected.
9. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Configure MLD Snooping Querier
You can configure the settings for an MLD snooping querier.
 To configure an MLD snooping querier:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> Multicast > MLD Snooping > Querier Configuration.

NETGEAR ProSafe XS728T Specifications

General

Brand	NETGEAR
Model	ProSafe XS728T
Category	Switch
Language	English