NETGEAR ProSafe XS728T User Manual

Configure Switching
155
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
Configure Multicast Group Membership
By default, an interface is excluded from multicast groups but could be dynamically added to
any multicast group. You can manually add interfaces to a group (which changes the type of
the group from dynamic to static) and you can lock interfaces so that they cannot be added
dynamically to a group.
 To configure multicast group membership:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching > Multicast > Static Multicast Address > Multicast Group
Membership.
6. From the VLAN ID menu, select the VLAN ID for the VLAN in which the multicast group is
located.
If a name is associated with the VLAN, the name displays in the VLAN Name field.

NETGEAR ProSafe XS728T Specifications

General

Brand	NETGEAR
Model	ProSafe XS728T
Category	Switch
Language	English