NETGEAR ProSafe XS728T User Manual

Configure System Information
81
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
6. In the VLAN ID field, specify the VLAN on which DHCP snooping is enabled.
7. From the DHCP Snooping Mode menu, select Enable.
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Configure DHCP Snooping Interface Settings
Use the DHCP Snooping Interface Configuration page to view and configure each port as a
trusted or untrusted port. Any DHCP responses received on a trusted port are forwarded. If a
port is configured as untrusted, any DHCP (or BootP) responses received on that port are
discarded.
 To configure DHCP snooping interface settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select System> Services > DHCP Snooping > Interface Configuration.

NETGEAR ProSafe XS728T Specifications

General

Brand	NETGEAR
Model	ProSafe XS728T
Category	Switch
Language	English