Configure Switching
154
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
The multicast group is added.
The following table describes the nonconfigurable information displayed on the page.
Remove a Multicast Group
You can remove a multicast group that you no longer need. Because the multicast MAC
address is the multicast group identifier. You remove a multicast group by removing the static
multicast address from the VLAN to which it is assigned.
 To remove one or more multicast groups:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching > Multicast > Static Multicast Address > Multicast Group
Configuration.
The Multicast Group Configuration page displays.
6. Select the check boxes for the statically added multicast addresses that you want to remove.
You cannot select a check box for a dynamically added multicast address.
7. Click the Delete button.
The multicast groups are removed.
Table 40. Multicast Group Configuration information
Field Definition
VLAN Name The VLAN name, if any, that is associated with the VLAN ID.
Type The type of multicast group, which is determined by the way in which
members are added to the group:
• Dynamic. Members are added dynamically to the multicast group.
By default, all groups are dynamic groups.
• Static. If you add static members to the multicast group (see
Configure Multicast Group Membership on page 155), the group
becomes a static group.
To Next Page
Loading...
Need help?
General