NETGEAR ProSafe XS728T User Manual

Configure Switching
95
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> VLAN > Basic > VLAN Configuration.
6. In the VLAN ID field, specify the VLAN identifier for the new VLAN.
The range of the VLAN ID can be from 2 to 4093. VLAN ID 1 is reserved for the default
VLAN.
7. In the VLAN Name field, specify a name for the VLAN.
The VLAN name can be up to 32 alphanumeric characters long, including blanks. The
default is blank. VLAN ID 1 always uses the name Default.
8. The VLAN Type field displays the type of the VLAN that you are configuring.
You cannot change the type of the default VLAN (VLAN ID = 1): it is always type Default.
When you create a VLAN using this page, its type is always Static. A VLAN that is
created by GVRP registration initially uses a type of Dynamic. When configuring a
dynamic VLAN, you can change its type to Static.
9. Click the Add button.
The VLAN is added to the switch.
10. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Delete a VLAN
 To delete a VLAN from the switch:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.

NETGEAR ProSafe XS728T Specifications

General

Brand	NETGEAR
Model	ProSafe XS728T
Category	Switch
Language	English