FIG
12:1 Roof removal. Releasing
the
locknuts
Ćrom
the
lock rods
ReĆitting:
1 Install the crossmember,
locks
and the
rods.
2 Tighten the nuts to obtain an equal tension between
both
rods
and a
normal stiffness in the
operation of
the handle.
Carefully
lock the locknuts. ĆÆhis
operation
can be done
without removing
the
roof
and should
be
performed
whenever the handle fails to lock
correctly.
3
Protect the rear of the roof with
adhesive
taoe.
4 Engage the tension springs equipped with the upper
rollers. under the roof.
106
5
Engage the
panel (see
FIG 12:2),
so as
to engage
the lower slider rollers under the roof
.
6
Position
and
f ix the crossmember
onto the oanel.
7 Actuate the sunroof
and
check
Ćor
correct oDeration.
lĆ
when
operating
the sunroof it
gets
jammed
sideways,
close the
rooĆ
and check the
lower
rollers
for
oosition
on the sliders.
,Adjust the sliders
so
that the rollers
start together up the slopes when the rooĆ starts to
move.
1
2
:3 Door
catch adjustments
1 Ensure that the
latch
and its control
is
operating
correctly and
that the door hinges are tight and
not
d istorted.
2 Refer to FIG 12:3 and loosen the three catch
attachment screws and
move
the catch to
its furthest
outboard adjustment.
3 Press, without
releasing,
the outer handle
knob
and
close the door
slowly,
pushing
it hard in the closed
oosition.
4
Open the door and
release the control knob.
5 Tighten the catch attachment screws.
6 Check the door
Ćor
correct closing and
locking and
recorrect
as necessary.
The sole and
the rod of the
door
catch should
be
oiled
occasionally but do not
put
oil
onto the nylon
saĆety
stooe.
12 :4 Removing
and
replacing the
windscreen
glass
Removal:
1 lf the
glass
is being
removed because
it is cracked,
stick adhesive
tape or adhesive
paper
over
the whole
su rface.
2 Ensure that
the ventilator intake
inlets
and
grilles
are
closed and
the defrosier
slits
are
covered.
3
Remove the windscreen
wiper arms.
4 Remove the sunvisor
and the rear view
mirror.
FIG 12:2
Refitting the sun rooĆ
FIG 12:3
Adjusting the door catches