Chapter 4 Advanced Configuration
© Polycom, Inc. 121 ViewStation FX/VS 4000 User’s Guide
Gateway
The configuration of this screen has no effect if you are not using a
Gatekeeper or Gateway.
Use this screen to configure the gateway that is used to dial gateway
calls. You can configure a prefix or suffix that is sent to the
gatekeeper. This prefix identifies which gateway is used to dial a call
at a particular data rate. The gatekeeper then directs the call to the
gateway that is identified with a prefix.
In the following example, the ViewStation FX or VS4000 inserts the
prefix “90” before the number when dialing a 256K Gateway call.
The prefix tells the Gatekeeper which Gateway to use to dial the
256K call.
Figure 4-19. H.323 Gateway Screen
Gatekeeper
Use this screen to configure an H.323 gatekeeper. If you do not want
to access a gatekeeper, select the Off option. To specify
gatekeeper, select the Specify option and enter the gatekeeper’s IP
address on the following line. This information is available from your
network administrator. To have the ViewStation FX or VS4000
automatically find an available gatekeeper, select the Auto option.
When you have finished, highlight the Save icon and press the
button on the remote control.
To Next Page
Loading...
Need help?
General
