Chapter 5 System Information and Diagnostics
© Polycom, Inc. 141 ViewStation FX/VS 4000 User’s Guide
Multi-Point Setup
The Multi-Point Setup screen allows you to choose a viewing mode
for multi-point calls.
Figure 5-6. Multi-Point Setup Screen
For information about multi-point viewing modes, see the Multi-point
Viewing Modes section of Chapter 2, Using the ViewStation FX and
the VS4000.
Dialing Speeds
Use the Dialing Speed screen to set the dialing speeds for each type
of call. The speeds you set in this screen are available for selection
when placing a call. You can set a limited number of speeds to
simplify dialing for your users.
Call Preference
Use this screen to set the types of call that can be dialed from the
ViewStation FX or VS4000. If you do not have the proper equipment
connected for the type of call you've chosen, you see a message
instructing you to power off the ViewStation FX or VS4000 and
connect the equipment.
Numbers
This screen is used to enter numbers that other sites will dial to call
your ViewStation FX or VS4000.
To Next Page
Loading...
Need help?
General
