Triumph Street Cup User Manual

Maintenance And Adjustment
101
Tighten both adjuster lock nuts to
20 Nm and the rear wheel spindle nut to
110 Nm.
Repeat the chain adjustment check.
Readjust if necessary.
Warning
Operation of the motorcycle with
insecure adjuster lock nuts or a loose
wheel spindle may result in impaired
stability and handling of the
motorcycle. This impaired stability and
handling may lead to loss of control or
an accident.
Check the rear brake effectiveness.
Rectify if necessary.
Warning
It is dangerous to operate the
motorcycle with defective brakes; you
must have your authorised Triumph
dealer take remedial action before you
attempt to ride the motorcycle again.
Failure to take remedial action may
reduce braking efficiency leading to
loss of motorcycle control or an
accident.
Chain and Sprocket Wear Inspection
Warning
Never neglect chain maintenance and
always have chains installed by an
authorised Triumph dealer. Use a
genuine Triumph supplied chain as
specified in the Triumph Parts
Catalogue.
The use of non‑approved chains may
result in a broken chain or may cause
the chain to jump off the sprockets
leading to loss of motorcycle control or
an accident.
Caution
If the sprockets are found to be worn,
always replace the sprockets and drive
chain together.
Replacing worn sprockets without also
replacing the chain will lead to
premature wear of the new sprockets.
10-20
KG
2
1
1. Measure across 20 links
2. Weight

Triumph Street Cup Specifications

General

Engine Capacity	900 cc
Max Torque	80 Nm @ 3, 230 rpm
Fuel System	Multipoint sequential electronic fuel injection
Transmission	5-speed
Frame	Tubular steel cradle
Rear Suspension	KYB twin shocks with adjustable preload, 120 mm rear wheel travel
Front Brakes	Single 310 mm disc, Nissin 2-piston floating caliper, ABS
Dry Weight	200 kg
Bore x Stroke	84.6 x 80 mm
Compression Ratio	10.55:1
Final Drive	Chain
Clutch	Wet, multi-plate assist clutch
Front Tyre	100/90-18
Engine Type	Liquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Max Power	55 PS (54 hp) @ 5, 900 rpm
Exhaust	Brushed stainless steel twin silencers
Front Suspension	41mm forks
Rear Brakes	Single 255 mm disc, Nissin 2-piston floating caliper, ABS
Seat Height	780 mm
Fuel Tank Capacity	12 L
Swingarm	Twin-sided, tubular steel
Front Wheel	18 x 2.75 in
Rear Wheel	17 x 4.25 in
Instrument Display and Functions	Analogue speedometer, fuel gauge and gear position indicator
Width (Handlebars)	740 mm
Rake	25.5°