Triumph Street Cup User Manual

Cleaning And Storage
136
Where to be Careful
Caution
Do not spray any water at all near the
air intake duct. The air intake duct is
normally located under the rider’s seat,
under the fuel tank or near the
steering head. Any water sprayed in
this area could enter the airbox and
engine, causing damage to both items.
Caution
Use of high pressure spray washers is
not recommended. When using
pressure washers, water may be
forced into bearings and other
components causing premature wear
from corrosion and loss of lubrication.
Avoid spraying water with any great
force near the following places:
• Instruments;
• Brake cylinders and brake calipers;
• Under the fuel tank;
• Air intake duct;
• Headstock bearings;
• Wheel bearings.
Note:
• Use of soaps that are highly
alkaline will leave a residue on
painted surfaces, and may also
cause water spotting. Always use a
low alkaline soap to aid the cleaning
process.
Washing
Prepare a mixture of cold water and
mild automotive cleaner. Do not use a
highly alkaline soap as commonly found
at commercial car washes because it
leaves a residue.
Wash the motorcycle with a sponge or
soft cloth. Do not use abrasive scouring
pads or steel wool. They will damage the
finish.
Rinse the motorcycle thoroughly with
cold water.

Triumph Street Cup Specifications

General

Engine Capacity	900 cc
Max Torque	80 Nm @ 3, 230 rpm
Fuel System	Multipoint sequential electronic fuel injection
Transmission	5-speed
Frame	Tubular steel cradle
Rear Suspension	KYB twin shocks with adjustable preload, 120 mm rear wheel travel
Front Brakes	Single 310 mm disc, Nissin 2-piston floating caliper, ABS
Dry Weight	200 kg
Bore x Stroke	84.6 x 80 mm
Compression Ratio	10.55:1
Final Drive	Chain
Clutch	Wet, multi-plate assist clutch
Front Tyre	100/90-18
Engine Type	Liquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Max Power	55 PS (54 hp) @ 5, 900 rpm
Exhaust	Brushed stainless steel twin silencers
Front Suspension	41mm forks
Rear Brakes	Single 255 mm disc, Nissin 2-piston floating caliper, ABS
Seat Height	780 mm
Fuel Tank Capacity	12 L
Swingarm	Twin-sided, tubular steel
Front Wheel	18 x 2.75 in
Rear Wheel	17 x 4.25 in
Instrument Display and Functions	Analogue speedometer, fuel gauge and gear position indicator
Width (Handlebars)	740 mm
Rake	25.5°