Triumph Street Cup User Manual

How To Ride The Motorcycle
72
Check that the engine stop switch is in
the RUN position.
Make sure the transmission is in neutral.
Turn the ignition switch on.
Note:
• When the ignition is switched on,
the instrument warning lights will
illuminate and will then go off
(except those which normally
remain on until the engine starts,
see page 29).
Pull the clutch lever fully into the
handlebar.
Leaving the throttle fully closed, push
the starter button until the engine
starts.
The motorcycle is equipped with starter
lockout switches. The switches prevent
the electric starter from operating when
the transmission is not in neutral with
the side stand down.
If the side stand is extended whilst the
engine is running, and the transmission
is not in neutral then the engine will
stop regardless of the clutch lever
position.
Moving Off
Pull in the clutch lever and select first
gear. Open the throttle a little and let
out the clutch lever slowly. As the
clutch starts to engage, open the
throttle a little more, allowing enough
engine speed to avoid stalling.

Triumph Street Cup Specifications

General

Engine Capacity	900 cc
Max Torque	80 Nm @ 3, 230 rpm
Fuel System	Multipoint sequential electronic fuel injection
Transmission	5-speed
Frame	Tubular steel cradle
Rear Suspension	KYB twin shocks with adjustable preload, 120 mm rear wheel travel
Front Brakes	Single 310 mm disc, Nissin 2-piston floating caliper, ABS
Dry Weight	200 kg
Bore x Stroke	84.6 x 80 mm
Compression Ratio	10.55:1
Final Drive	Chain
Clutch	Wet, multi-plate assist clutch
Front Tyre	100/90-18
Engine Type	Liquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Max Power	55 PS (54 hp) @ 5, 900 rpm
Exhaust	Brushed stainless steel twin silencers
Front Suspension	41mm forks
Rear Brakes	Single 255 mm disc, Nissin 2-piston floating caliper, ABS
Seat Height	780 mm
Fuel Tank Capacity	12 L
Swingarm	Twin-sided, tubular steel
Front Wheel	18 x 2.75 in
Rear Wheel	17 x 4.25 in
Instrument Display and Functions	Analogue speedometer, fuel gauge and gear position indicator
Width (Handlebars)	740 mm
Rake	25.5°