Triumph Street Cup User Manual

General Information
55
Fuel Requirement/Refuelling
P
b
cbny
Fuel Grade
Your Triumph engine is designed to use
unleaded fuel and will give optimum
performance if the correct grade of fuel
is used. Always use unleaded fuel with a
minimum octane rating of 91 RON.
In certain circumstances engine
calibration may be required. Always
refer to your authorised Triumph dealer.
Caution
The motorcycle can be permanently
damaged if it is allowed to operate with
the incorrect grade of fuel or incorrect
engine calibration. Always make sure
the fuel used is of the correct grade
and quality. Damage caused by using
the incorrect fuel or engine calibration
is not considered a manufacturing
defect and will not be covered under
warranty.
Caution
The exhaust system for this
motorcycle is fitted with a catalytic
converter to help reduce exhaust
emission levels. Use of leaded fuel will
damage the catalytic converter. In
addition, the catalytic converter can be
permanently damaged if the
motorcycle is allowed to run out of fuel
or if the fuel level is allowed to get very
low. Always make sure you have
adequate fuel for your journey.
Note:
• The use of leaded fuel is illegal in
some countries, states or territories.

Triumph Street Cup Specifications

General

Engine Capacity	900 cc
Max Torque	80 Nm @ 3, 230 rpm
Fuel System	Multipoint sequential electronic fuel injection
Transmission	5-speed
Frame	Tubular steel cradle
Rear Suspension	KYB twin shocks with adjustable preload, 120 mm rear wheel travel
Front Brakes	Single 310 mm disc, Nissin 2-piston floating caliper, ABS
Dry Weight	200 kg
Bore x Stroke	84.6 x 80 mm
Compression Ratio	10.55:1
Final Drive	Chain
Clutch	Wet, multi-plate assist clutch
Front Tyre	100/90-18
Engine Type	Liquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Max Power	55 PS (54 hp) @ 5, 900 rpm
Exhaust	Brushed stainless steel twin silencers
Front Suspension	41mm forks
Rear Brakes	Single 255 mm disc, Nissin 2-piston floating caliper, ABS
Seat Height	780 mm
Fuel Tank Capacity	12 L
Swingarm	Twin-sided, tubular steel
Front Wheel	18 x 2.75 in
Rear Wheel	17 x 4.25 in
Instrument Display and Functions	Analogue speedometer, fuel gauge and gear position indicator
Width (Handlebars)	740 mm
Rake	25.5°