Triumph Street Cup User Manual

Maintenance And Adjustment
111
Wheel Bearings Inspection
Warning
Riding with worn or damaged front or
rear wheel bearings is dangerous and
may cause impaired handling and
instability leading to an accident. If in
doubt, have the motorcycle inspected
by an authorised Triumph dealer before
riding.
If the wheel bearings in the front or rear
wheel allow play in the wheel hub, are
noisy, or if the wheel does not turn
smoothly, have your authorised Triumph
dealer inspect the wheel bearings.
The wheel bearings must be inspected
at the intervals specified in the
scheduled maintenance chart.
Inspecting the Wheel Bearings
To inspect the wheel bearings:
Position the motorcycle on level ground,
in an upright position.
Raise the front wheel off the ground
and support the motorcycle.
Standing at the side of the motorcycle,
gently rock the top of the front wheel
from side to side.
If any free play can be detected, ask
your authorised Triumph dealer to
inspect and rectify any faults before
riding.
Reposition the lifting device and repeat
the procedure for the rear wheel.
Remove the support and place the
motorcycle on the side stand.

Triumph Street Cup Specifications

General

Engine Capacity	900 cc
Max Torque	80 Nm @ 3, 230 rpm
Fuel System	Multipoint sequential electronic fuel injection
Transmission	5-speed
Frame	Tubular steel cradle
Rear Suspension	KYB twin shocks with adjustable preload, 120 mm rear wheel travel
Front Brakes	Single 310 mm disc, Nissin 2-piston floating caliper, ABS
Dry Weight	200 kg
Bore x Stroke	84.6 x 80 mm
Compression Ratio	10.55:1
Final Drive	Chain
Clutch	Wet, multi-plate assist clutch
Front Tyre	100/90-18
Engine Type	Liquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Max Power	55 PS (54 hp) @ 5, 900 rpm
Exhaust	Brushed stainless steel twin silencers
Front Suspension	41mm forks
Rear Brakes	Single 255 mm disc, Nissin 2-piston floating caliper, ABS
Seat Height	780 mm
Fuel Tank Capacity	12 L
Swingarm	Twin-sided, tubular steel
Front Wheel	18 x 2.75 in
Rear Wheel	17 x 4.25 in
Instrument Display and Functions	Analogue speedometer, fuel gauge and gear position indicator
Width (Handlebars)	740 mm
Rake	25.5°