Triumph Street Cup User Manual

General Information
63
Seat Removal and Installation
Warning
To prevent detachment of a seat
during riding, after fitting always grasp
the seat and pull firmly upwards.
If the seat is not correctly secured it
will detach from the lock.
A loose or detached seat could cause
loss of motorcycle control and an
accident.
Street Twin, Street Cup, Thruxton,
Thruxton R, Bonneville T100 and
Bonneville T120
Seat Removal
To remove the seat:
1
1. Seat lock
Insert the ignition key into the seat lock
and turn it anticlockwise.
This will release the seat from its lock.
Slide the seat upwards and rearwards
for complete removal from the
motorcycle.
Street Twin, Street Cup, Thruxton,
Thruxton R, Bonneville T100 and
Bonneville T120
Seat Installation
To refit the seat:
Engage the seat's tongue underneath
the bracket near the fuel tank.
Line up the hinges and press down at
the rear to engage the seat lock.
Note:
• An audible click can be heard when
the seat is fully engaged into its
lock.
Street Scrambler Seat Removal
Note:
• If a passenger seat is fitted, it must
be removed before removing the
rider’s seat.
• If a luggage rack is fitted, the
rider’s seat can be removed without
removing the luggage rack.

Triumph Street Cup Specifications

General

Engine Capacity	900 cc
Max Torque	80 Nm @ 3, 230 rpm
Fuel System	Multipoint sequential electronic fuel injection
Transmission	5-speed
Frame	Tubular steel cradle
Rear Suspension	KYB twin shocks with adjustable preload, 120 mm rear wheel travel
Front Brakes	Single 310 mm disc, Nissin 2-piston floating caliper, ABS
Dry Weight	200 kg
Bore x Stroke	84.6 x 80 mm
Compression Ratio	10.55:1
Final Drive	Chain
Clutch	Wet, multi-plate assist clutch
Front Tyre	100/90-18
Engine Type	Liquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Max Power	55 PS (54 hp) @ 5, 900 rpm
Exhaust	Brushed stainless steel twin silencers
Front Suspension	41mm forks
Rear Brakes	Single 255 mm disc, Nissin 2-piston floating caliper, ABS
Seat Height	780 mm
Fuel Tank Capacity	12 L
Swingarm	Twin-sided, tubular steel
Front Wheel	18 x 2.75 in
Rear Wheel	17 x 4.25 in
Instrument Display and Functions	Analogue speedometer, fuel gauge and gear position indicator
Width (Handlebars)	740 mm
Rake	25.5°