Triumph Street Cup User Manual

Maintenance And Adjustment
91
When correct, oil should be visible in the
sight glass at a point midway between
the upper (maximum) and lower
(minimum) markings on the sight glass.
Note:
• An accurate indication of the level
of oil in the engine is only shown
when the engine is at normal
operating temperature and the
motorcycle is upright (not on the
side stand).
If it is necessary to top up the oil level,
remove the filler plug and add oil, a little
at a time, until the level registered in
the sight glass is correct.
Caution
Make sure no foreign matter or
contamination enters the engine
during an oil change or top up.
Contamination entering the engine
may lead to engine damage.
Once the correct level is reached, fit and
tighten the filler plug.
Oil and Oil Filter Change
Warning
Prolonged or repeated contact with
engine oil can lead to skin dryness,
irritation and dermatitis. In addition,
used engine oil contains harmful
contamination that can lead to skin
cancer. Always wear suitable
protective clothing and avoid skin
contact with used oil.
Warning
The oil may be hot to the touch. Avoid
contact with the hot oil by wearing
suitable protective clothing, gloves, eye
protection, etc. Contact with hot oil may
cause the skin to be scalded or burned.
Warning
If the engine has recently been
running, the exhaust system will be
hot. Before working on or near the
exhaust system, allow sufficient time
for the exhaust system to cool as
touching any part of a hot exhaust
system could cause burn injuries.
The engine oil and filter must be
renewed in accordance with scheduled
maintenance requirements.
To change the engine oil and filter,
follow the instructions.
Warm up the engine thoroughly then
stop the engine. Secure the motorcycle
on the side stand.
Allow the oil to settle for five minutes
before draining.

Triumph Street Cup Specifications

General

Engine Capacity	900 cc
Max Torque	80 Nm @ 3, 230 rpm
Fuel System	Multipoint sequential electronic fuel injection
Transmission	5-speed
Frame	Tubular steel cradle
Rear Suspension	KYB twin shocks with adjustable preload, 120 mm rear wheel travel
Front Brakes	Single 310 mm disc, Nissin 2-piston floating caliper, ABS
Dry Weight	200 kg
Bore x Stroke	84.6 x 80 mm
Compression Ratio	10.55:1
Final Drive	Chain
Clutch	Wet, multi-plate assist clutch
Front Tyre	100/90-18
Engine Type	Liquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Max Power	55 PS (54 hp) @ 5, 900 rpm
Exhaust	Brushed stainless steel twin silencers
Front Suspension	41mm forks
Rear Brakes	Single 255 mm disc, Nissin 2-piston floating caliper, ABS
Seat Height	780 mm
Fuel Tank Capacity	12 L
Swingarm	Twin-sided, tubular steel
Front Wheel	18 x 2.75 in
Rear Wheel	17 x 4.25 in
Instrument Display and Functions	Analogue speedometer, fuel gauge and gear position indicator
Width (Handlebars)	740 mm
Rake	25.5°