Xerox 4112 System Administration Guide

Using the Scan Service
5-12 System Administration Guide
Xerox 4112/4127 Copier/Printer
Configuration on the computer
This section describes the configuration procedure for the computer.
Using with FTP
Create a destination directory/folder for your files. this directory/folder should be created on
the FPT server where you logged in.
Using with SMB
Create a folder on the computer and configure it as a shared folder.
Configuration of the Job Flow
The following is the procedure to use the job flow scan function:
• Enabling the port and setting TCP/IP
Enable the SOAP port, SNMP port, and Internet service port, and set IP addresses on the
machine.
• Configuring the SNMP port
Configure the transport protocol for the SNMP port using CentreWare Internet Services.
• Configuring the computer
Enabling the ports and setting the IP addresses
In order to use the job flow service, enable the SOAP port, SNMP port, and Internet service port,
and set IP addresses. The procedure for setting the machine follows.
Note
The configuration can also be performed using CentreWare Internet Services. Refer to “Using
CentreWare Internet Services”.
1. Enter the System Administrator Mode (Chapter 1 Entering the System Administrator mode
on page 1-10.)
2. Enable the SOAP port.
a. Select System Settings.
b. Select Connectivity & Network Setup.
c. Select Port Settings.
d. Select SOAP and then select Change Settings.
e. Select Port Status and select Change Settings.
f. Select Enable and then select Save.
g. Select Close
Downloaded From ManualsPrinter.com Manuals

Xerox 4112 Specifications

General

Brand	Xerox
Model	4112
Category	All in One Printer
Language	English