Error Messages and Codes 3-47
Replace Fuser or Fuser is Near End of Life
■ Print the Supplies Usage page to verify remaining life and Fuser install date.
■ Cycle printer power.
■ If the problem persists, follow the procedure below
Note
The “Fuser is Near End of Life” is a warning. “Replace Fuser” is a hard stop.
ng
To avoid the potential of electric shock, ensure the power to the printer is off
and the power cord is disconnected from the wall outlet prior to performing
Step 1 in the following troubleshooting procedure..
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
EEPROM Board, PL 10.1.16 “Laser Unit” on page 10-22
CRUM Harness Assembly, PL 10.1.15 “Fuser Assembly” on page 10-21
Troubleshooting Procedure Table
Steps Actions and Questions Yes No
1
Check the connector to the Fuser
Assembly for damage.
Connect properly
or replace the
parts concerned.
Power cycle the
printer.
Go to Step 2.
2
Does the error recur after the Fuser has
been replaced with a new one?
Go to Step 3. Complete
3
Replace the EEPROM Board.
Does the error recur?
Troubleshoot using
the wiring diagram
“Fuser Assembly”
on page 10-21
Replace the
Engine Control
Board,
page 8-107.
Complete
To Next Page
Loading...
Need help?
General