Xerox PHASER 6250 Service Manual

4-10 Phaser 6250 Color Laser Printer Service Manual
Printer Inoperable after Power Switch is On
No mechanical initialization observed after the Power Switch is turned On. One
possible cause of this condition is the protection circuitry on the LVPS has detected
an overload condition and temporarily stopped all output. This protective shutdown
lasts no more than 5 minutes following removal of the overload.
Initial Actions
■ Turn off the printer’s Power Switch and remove the Power Cord.
■ Remove the Image Processor board (page 8-110).
■ Wait 5 minutes before restoring power to allow the protection circuitry to reset.
Note
The Control Panel and indicator LEDs are disabled during print engine testing
with the Engine Only Test Print.
Troubleshooting References
Applicable Parts Wiring and Plug/Jack Map References
Low Voltage Power Supply, PL 12.1.10 "Power Supply" on page 10-16
Control Panel, PL 1.1.1 "Image Processor Board" on page 10-26
Image Processor Board, PL 12.1.4 "Image Processor Board" on page 10-26
Troubleshooting Procedure Table
Steps Action and Questions Yes No
1
Test the print engine.
1. Power up the printer with the Image
Processor Board removed.
2. Run the Engine Only Test Print
(page 5-9).
Was the Test Print successful?
Go to Step 2. Go to Step 3.
2
Check the Image Processor Board (or
one of its removable components,
Memory, NVRAM, etc.), or the Control
Panel as one of these components are
most likely responsible for the overload
condition.
Does the problem still persist.
Go to Step 3. Complete.

Xerox PHASER 6250 Specifications

General

Brand	Xerox
Model	PHASER 6250
Category	Printer
Language	English