Theory of Operation 2-29
Chute Assembly Out
1. Full Stack (Output Tray Full) Sensor: Detects a full output tray (over
accumulation of print media) by the position of the actuator. This is only checked
when the paper is feeding into the exit.
2. Duplex Jam Sensor: Detects when print media has reached and passed
through the duplex roller based on the position of the actuator.
3. Duplex Roller: The duplex roller rotates under drive from the duplex motor and
feeds the print media returned from the chute assembly exit to the roll turn in the
retard housing assembly.
4. Gear (Main Drive): See Feed Roll Assembly.
5. Tray 1 Gear: See Feed Roll Assembly.
6. Feed Roll Assembly: When the Tray 1 feed soleniod energizes, the Tray 1
gear and the idler gear are engaged by the force of the spring solenoid. The feed
roll rotates from the drive of the Main Drive Assembly and feeds paper from
6250-059
1
2
3
4
5
6
7
8
To Next Page
Loading...
Need help?
General