Xerox PHASER 6250 Service Manual

Error Messages and Codes 3-9
Service Diagnostic Tests
Test Front Panel Display and Test Definition
Print Service Menu Map - Prints the service diagnostics menu map and exits service
diagnostics.
General Status - Provides the following print engine status:
Status <No Status to Report>
NOTE This is current status since
entering diagnostics only. It is
not a Fault Log. If Ready is
reached, the register is
cleared.
No Status to Report = the printer
is online and ready to print.
Displays an engine status that will
prevent printing. Status is
displayed sequentially, one line at
a time.
Engine Board
ROM Version
Engine FW: #.#.# Displays the engine firmware
version installed.
Printer
Configuration
Memory: ###MB
Hard Drive: Not Installed or
Installed
HCF: Installed
Not Installed
Displays current memory installed.
Detects presence of Hard Drive
option.
Detects presence of High-Capacity
Feeder option.
Ambient
Temperature/
Humidity
Temperature: XX
o
C
Humidity: ## %
Displays the current Temperature
and Humidity for the printer.
Fuser
Temperature
Temperature: XX
o
C
Displays the printers current Fuser
temperature.
Fault History Device Status
Jams
Hardware Errors
Firmware Errors
Fan Motors
CTD (ADC) Sensor Errors
Fuser Failure
Laser Failure
Life Over
Trays
Miscellaneous
CRUMS
Displays Fault occurrence since
last power cycle.
Test Prints - Prints test prints stored in the Engine Control Board. The prints are used by
service personnel to identify, repair and validate the operability of the printer.

Xerox PHASER 6250 Specifications

General

Brand	Xerox
Model	PHASER 6250
Category	Printer
Language	English