Xerox PHASER 6250 Service Manual

Error Messages and Codes 3-63
Wrong Paper Size; Load Tray 2 with [size] [type]
■ Remove Tray 2 and inspect the tray cavity of the printer to ensure that it is
free of obstructions or debris.
■ Ensure that the tray is loaded with supported media.
■ Ensure that the media guides are properly adjusted.
■ Reinstall the tray.
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Note
This is a media SIZE mismatch error.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
Paper Size Switch Assembly, PL 3.2.4 “Paper Tray 2” on page 10-17
Troubleshooting Procedure Table
Steps Actions and Questions Yes No
1
Check the following for evidence of fault
or damage:
Paper Size Switch Tray [2], PL 3.2.4
Actuators on the right side of Tray [2]
Replace the parts
concerned.
Go to Step 2.
2
Use service diagnostics to test the Tray
[2] Paper Size Switches. Use the table
below for reference.
Do the switches function correctly?
Replace Engine
Control Board,
page 8-107.
Go to Step 4.
3
Does the printer function correctly after
replacing the Engine Control Board?
Complete Go to Step 4.
4
Verify the pertinent voltages on pins
P/J47 – 1 <=> P/J47 – 3
P/J47 – 2 <=> P/J47 – 3
P/J47 – 4 <=> P/J47 – 3
Correspond to the paper size switch
position chart below.
Go to Step 5. Replace the Paper
Size Switch
page 8-26.

Xerox PHASER 6250 Specifications

General

Brand	Xerox
Model	PHASER 6250
Category	Printer
Language	English