Xerox PHASER 6250 Service Manual

Error Messages and Codes 3-51
2
Use service diagnostics to test the Toner
Low Sensor. If the test fails check the
sensor connector, if the connector is ok
replace the Toner Low Sensor for the
problem color.
Does the error recur?
Go to Step 3. Complete
3
Use service diagnostics to test the Toner
Motor.
Caution: Run this test for ONLY 5
seconds to avoid packing the toner.
Does the Toner Motor function correctly?
Check the toner
stirring auger or
gear for damage.
Go to Step 4.
4
Replace the Toner Motor.
Does this fix the problem?
Complete Go to Step 5.
5
Verify the auger tube of the problem color
is full of toner near the hopper end.
Go to Step 6. Inspect the toner
cartridge for
dispense
problems.
6
Verify that the voltage between P/J 51-21
<=> P/J 60-2 on the Motor Driver Board is
24 VDC
Go to Step 7. Replace the Motor
Driver Board,
page 8-101
7
Troubleshoot using the wiring diagrams:
See “Developer Section 1” on
page 10-19. and See “Drive Section” on
page 10-18.
Replace any defective parts.
Does the error still appear?
Replace the
Engine Control
Board,
page 8-107.
Complete
Troubleshooting Procedure Table (Continued)
Steps Actions and Questions Yes No

Xerox PHASER 6250 Specifications

General

Brand	Xerox
Model	PHASER 6250
Category	Printer
Language	English