Xerox PHASER 6250 Service Manual

3-72 Phaser 6250 Color Laser Printer Service Manual
Fuser Failure (cont’d)
Fuser CRUM Failure
Code 45: CRUM data revise failure
Code 46: CRUM setting value failure
Code 47: This is the generic fuser code displayed when the printer cannot generate a
specific error. This error code can represent any fuser error code from 40 through 46.
In this instance, all of the Fuser Failure troubleshooting procedures need to be
completed until the error is resolved..
W
arn
i
ng
To avoid the potential of electric shock, ensure the power to the printer is off
and the power cord is disconnected from the wall outlet prior to performing
Step 2 of the following troubleshooting procedure..
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
EEPROM Board, PL 10.1.16 “Fuser Assembly” on page 10-21
FSR 2 Harness Assembly, PL 5.1.9 “Laser Unit” on page 10-22
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
Check the Fuser Assembly for evidence
of fault or damage.
Replace the parts
concerned.
Go to Step 2.
2
Remove the Fuser Assembly and check
for broken or bent pins.
Replace the parts
concerned.
Go to Step 3.
3
Does the error recur after the Fuser
Assembly has been replaced with a new
one?
Go to Step 4. Complete
4
Troubleshoot using the wiring diagram
“Fuser Assembly” on page 10-21.
Does the printer function correctly after
replacing any defective parts?
Go to Step 5. Replace the
Assembly,
Harness Fuser PL
13.1.
5
Troubleshoot using the wiring
diagrams“Laser Unit” on page 10-22 and
“Fuser Assembly” on page 10-21 for the
EEPROM Harness.
Replace the
Engine Control
Board, page 8-107.
Replace
EEPROM
Harness
Assembly,
PL 13.1.10.

Xerox PHASER 6250 Specifications

General

Brand	Xerox
Model	PHASER 6250
Category	Printer
Language	English