Theory of Operation 2-21
8. Gear Idler Feed: See Paper Pick Rollers.
9. Feed Solenoid: Controls the operation (rotation/stop) of the Feed Roller
Assembly by controlling the rotations of the Gear Feed.
10. Low Paper Sensor: The actuator lowers as print media is used in the tray.
When the actuator lowers to a pre-determined postion, it blocks the sensor beam
to trigger a low paper status. The actuator position can be seen from the front of
the paper tray allowing confirmation of the print media quantity.
11. Paper Feed Roll: See paper Pick Rollers.
12. Roll Turn Assembly: The roll turn assembly receives drive energy from the
main drive through the turn clutch and transports the print media out of the paper
tray to the registration roller.
High-Capacity Feeder Trays 3 and 4
Note
The callouts in the following figure refer to the identifying numbers in the
preceding paragraphs. The T3 and T4 in the callouts identify the tray.
Tray 2 paper pick assembly has a different part number than the HCF Tray 3 and
Tray 4 paper pick assembly.
6250-446
12(T3)
11(T3)
3(T3)
2(T3)
4(T3)
9(T3)
5(T3)
5(T4)
9(T4)
4(T4)
2(T4)
11(T4)
3(T4)
12(T4)
To Next Page
Loading...
Need help?
General