ENGINE (YP250R)
3-27
IP
• Before checking the engine oil level, wait a few
minutes until the oil has settled.
• Do not screw the dipstick in when inspecting
the oil level.
NOTICE
EWA37P1003
Do not allow foreign materials to enter the
crankcase.
5. Start the engine, warm it up for several min-
utes, and then turn it off.
6. Check the engine oil level again.
IP
Before checking the engine oil level, wait a few
minutes until the oil has settled.
7. Install:
• Dipstick
EAS20780
CHANGING THE ENGINE OIL
1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
• Engine oil filler cap “1”
• Engine oil drain bolt “2”
(along with the gasket)
4. Drain:
• Engine oil
(completely from the crankcase)
5. If the oil strainer is also to be cleaned, per-
form the following procedure.
▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Remove the oil strainer cover “1” and oil
strainer “2”.
b. Install a new O-ring “3”.
c. Install the oil strainer cover.
Type
SAE 10W-30, SAE 10W-40, SAE
15W-40, SAE 20W-40 or SAE
20W-50
Recommended engine oil grade
API service SF, SG type or high-
er, JASO standard MA
–20 –10 0
10
20 30 40 50 ˚C
SAE 10W-30
SAE 15W-40
SAE 20W-40
SAE 20W-50
SAE 10W-40
SAE 10W-50
10 30 50 70 90 1100 130 ˚F
a
b
1
1
1
2
2
3
1
New
To Next Page
Loading...
Need help?
General
