Application Deployment
145
6. Touch OK.
7. On the host computer, open a command prompt window and use the adb command:
adb devices
The following displays:
List of devices attached
XXXXXXXXXXXXXXX device
(where XXXXXXXXXXXXXXX is the device number).
NOTE: If device number does not appear, ensure that ADB drivers are installed properly.
8.
Enter this command:
adb reboot recovery
The System Recovery screen appears.
9. Press the Volume Up and Volume Down buttons to navigate to apply from adb.
10. Press the Power button.
11. Press the Volume Up and Volume Down buttons to navigate to Full OTA Package or Diff OTA Package.
12. Press the Power button.
13. On the host computer command prompt window enter this command:
adb sideload <file>
where: <file> = the path and filename of the zip file.
The System Update installs (progress appears as percentage in the Command Prompt window) and then the
Recovery screen appears.
14. Press the Power button to reboot the device.
Verifying System Update Installation
To check that the system update installed properly:
1. On the device, swipe down from the Status bar to open the Quick Access panel and then touch .
2. Touch System > About phone.
3. Scroll down to Build number.
4. Ensure that the build number matches the new system update package file number.
Performing an Enterprise Reset
An Enterprise Reset erases all user data in the /data partition, including data in the primary storage locations
(
/sdcard and emulated storage).
Before performing an Enterprise Reset, provision (backup) all necessary configuration files and restore them after
the reset.
Perform Enterprise Reset using microSD card or using ADB.
Downloading the Enterprise Reset Package
To download the system update package:
1. Go to the Zebra Support & Downloads web site, www.zebra.com/support.
To Next Page
Loading...
Need help?
General
