Maintenance and Troubleshooting
157
Cleaning
CAUTION: Always wear eye protection.
Read warning label on compressed air and alcohol product before using.
If you have to use any other solution for medical reasons please contact Zebra for more information.
WARNING!Avoid exposing this product to contact with hot oil or other flammable liquids. If such exposure occurs,
unplug the device and clean the product immediately in accordance with these guidelines.
Materials Required for Cleaning
• Alcohol wipes
• Lens tissue
• Cotton tipped applicators
• Isopropyl alcohol
• Can of compressed air with a tube
Cleaning the L10
Housing
Using the alcohol wipes, wipe the housing.
Display
The display can be wiped down with the alcohol wipes, but do not allow any pooling of liquid around the edges of
the display. Immediately dry the display with a soft, non-abrasive cloth to prevent streaking.
Power Connector
1. Remove the main battery from the L10 tablet.
2. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
3. Use the cotton tipped applicator dipped in alcohol to remove any grease and dirt near the connector area.
4. Repeat steps 2 and 3 a total of three times.
5. Spray compressed air on the connector area by pointing the tube/nozzle about ½ inch away from the surface.
CAUTION:
Do not point nozzle at yourself and others, ensure the nozzle or tube is pointed away from your face.
6.
Inspect the area for any grease or dirt, repeat if required.
Cleaning the Cradle Connector
Use this procedure to clean the connectors on a cradle:
1. Remove power from the cradle.
2. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
3. Rub the cotton portion of the cotton tipped applicator along the pins of the connector. Slowly move the
applicator back-and-forth from one side of the connector to the other. Do not let
leave any cotton residue on
the connector.
To Next Page
Loading...
Need help?
General
