4-9
Confidential
2 IF YOU REPLACE THE HEAD/CARRIAGE UNIT
<Operations>
2.1 Update the head property data (Maintenance mode 68)
2.2 Perform ink supply purge (Maintenance mode 76)
2.3 Check head nozzles (Maintenance mode 09)
2.4 Adjust head inclination
2.5 Adjustment of software correction for inclination/corrugation/ruled lines
(Maintenance mode 65)
2.6 Updating of paper feeding correction values (Maintenance mode 58)
2.7 Adjustment of margins in borderless printing (Maintenance mode 66)
2.8 Write head calibration data (Maintenance mode 02)
2.9 Check printing
2.10 Obtain machine information at the user site (Instruction to the end user)
<Requirements>
(1) USB cable (one piece)
(2) PC (Windows
®
XP or later)
Create a temporary folder in the C drive.
(3) Service setting tool (brusbsn.zip)
Make a copy of the service setting tool in the temporary folder in the C drive.
Extract the copied file and run "brusbsn.exe" by double-clicking.
(4) Download utility (FILEDG32.EXE)
Make a copy of the download utility in the temporary folder in the C drive.
(5) Maintenance driver (MaintenanceDriver.zip), if not installed
Make a copy of the maintenance driver in the temporary folder in the C drive.
Extract the copied file and install it, referring to Appendix 3 "Installing the
Maintenance Printer Driver."
(6) USB flash memory or SD card
(7) Data files of print patterns
To Next Page
Loading...
Need help?
General
