TS-12 Musician’s Manual Section 10 — Understanding the Sequencer
5
Sequencer Tracks
Each TS-12 sequence and song has twelve independent polyphonic Tracks on which you can
record notes, controllers, and program changes using local TS-12 sounds, remote MIDI
instruments, or both. These tracks are selected from the two Seq/Song Track pages, labeled
Seq/Song Tracks 1-6 and 7-12.
Let’s take a look at the Seq/Song Tracks pages:
Press Seq/Song Tracks 1-6. This takes you to the first of the two pages:
Track 1 Track 2 Track 3
Track 4 Track 5 Track 6
Replace
Track Sound
Seq/Song Tracks
1-6
7-12
Replace
w/FX
The LED above the Seq/Song Tracks 1-6 button lights, and the display shows the names of the
programs on the six tracks of the current song or sequence. Press the soft button next to a track to
select that track.
Press Seq/Song Tracks 7-12. This takes you to the second of the two Tracks pages:
Replace
Track Sound
Seq/Song Tracks
1-6
7-12
Replace
w/FX
Track 7 Track 8 Track 9
Track 10 Track 11 Track 12
The LED in the Seq/Song Tracks 7-12 button lights, and the display shows the names of the
programs on the remaining 6 sequence tracks. Tracks which show –UNDEFINED– instead of a
program name have not yet been defined (to define an undefined track you just select it).
A dot to the left of the track location indicates that there is recorded data on the track.
On these two pages you can select and layer the tracks of a sequence (by clicking or double-
clicking) just as you would on regular program bank pages. You can go back and forth between
Seq/Song Tracks 1-6 and 7-12 without losing what was selected or layered in the other half. The
LEDs above the two Seq/Song Tracks buttons tell you where you are.
To Next Page
Loading...
Need help?
General
