TS-12 Musician’s Manual Section 2 — System Page Parameters
13
PRESS-MODE Range: CHAN or PSET
This parameter determines the default Track Pressure setting for sounds as they are selected in
Sounds mode, or as they are assigned to a Track using the Replace Track Sound function in
Presets or Seqs/Songs. It also determines the default Track Pressure mode for all three Preset
Tracks when a Preset is selected. When PRESS-MODE=CHAN, all Sounds and Preset Tracks that
are set to KEY will have their Track Pressure mode automatically set to CHAN; Sounds and
Preset Tracks that have their Pressure mode set to OFF will be unaffected. The PRESS-
MODE=PSET setting disables this function, and installs the Sound and Preset Track Pressure
settings as stored in the Sounds or Presets.
The TS-12’s keyboard generates Channel pressure (Track PRESSURE=CHAN), but Sounds and
Presets can be programmed so that they respond to Poly-Key pressure via incoming MIDI (Track
PRESSURE=KEY). However, when Track PRESSURE=KEY, the sounds will not respond to the
Channel pressure generated by the TS-10’s own keyboard. The PRESS-MODE parameter
automatically compensates for this when PRESS-MODE=CHAN, ensuring that sounds created
with Poly-Key pressure will respond to Channel pressure generated by the TS-12’s keyboard.
WAKE-UP-MODE Range: SOUNDS, PRESETS, SEQ/SONG, DEFAULT,
PREVIOUS, LASTPAGE, GEN-MIDI
This parameter determines which mode the TS-12 will “wake-up” in after power-on.
• SOUNDS — Power-on in Sounds mode with the last Sound selected before power-off selected.
• PRESETS — Power-on in Presets mode with the last Preset selected before power-off selected.
• SEQ/SONG — Power-on in Sequencer mode with the last Sequence or Song selected.
• DEFAULT — Power-on in Sounds mode showing Program Bank U0-0. The default sound in
ROM will be selected.
• PREVIOUS — Power-on in the same mode the TS-12 was in when it was powered-off. Note
that if the TS-12 was in General MIDI mode when it was powered-off, it will wake-up in
Sounds mode.
• LASTPAGE — Power-on showing the last page that the TS-12 was on when it was powered-off.
This does not apply to some editing sub-pages. Note that if the TS-12 was in General MIDI
mode when it was powered-off, it will wake-up showing the last page that the TS-12 was on
before entering General MIDI mode.
• GEN-MIDI — Power-on in General MIDI mode.
Note: When WAKE-UP-MODE=GEN-MIDI, and Sampled Sounds had previously been loaded, the
Auto-Load prompt will be displayed before the TS-12 enters General MIDI. To prevent this, you
can first erase all Sampled Sounds from memory, as described in Section 14 — Understanding
Sampled Sounds.
To Next Page
Loading...
Need help?
General
