TS-12 Musician’s Manual Section 11 — Sequencer Parameters
21
Auditioning Event Edit Changes
If you press *EXIT* to leave the Event List function without having made any changes in the
track, you will simply be returned to the Edit Track page.
If you do change anything in the track, when you press *EXIT* you will be placed on a special
version of the Audition Play/Keep page, where you can audition the new track and the original
before deciding to either keep the new track, keep the old track or return to the Event Editor to
edit some more. The display shows:
• Press KEEP ORIGINAL to exit to the Edit Track page, leaving the track as it was before you
began editing.
• Press KEEP NEW to save the changes you have made to the track in Event List mode,
replacing the original track in memory. Or,
• Press EDIT EVENTS to re-enter the Event List mode with the changes you have made so far
intact, but retaining the option of keeping the original track later on.
When you have a song track on which the recorded data is shorter than the length of the actual
song steps, and you try to add any type of event after the end of the recorded data, you will
momentarily see the following error message: EVENT TIME PAST END OF RECORDED
TRACK. To remedy the problem, your song track data needs to be the same length as the song
steps. Set the RECORD-MODE=ADD; Press Record and Play, and let the song track run for the
entire length of the song (without recording any data). On the Audition page, select KEEP NEW
TRACK, and your song track will now be the same length as the Song Steps.
FILTER
The Filter command can be used to selectively remove events (such as notes, controllers and
program changes) from a track, or to copy selected events to a different track for further editing.
The Filter command has two modes, Erase and Copy. Depending on which mode is selected, it
will either remove the specified events from the track, or simply copy them to another track,
leaving the original track intact.
• Make sure the track you want to filter is selected.
• Press Edit Track twice (or press *MORE* from the Edit Track page), then select FILTER. The
display shows:
• Use the data entry controls to choose which type of events you would like filtered from the
track. The following event types can be filtered:
CNTL-1.MODWHL — Mod Wheel
CNTL-4.PEDAL — Foot Pedal
To Next Page
Loading...
Need help?
General
