Section 11 — Sequencer Parameters TS-12 Musician’s Manual
34
• Press Record/Play and play along with the track. The TS-12 will automatically enter record at
the first clock of the third bar and exit record on the last clock of the third bar.
EDIT TIMES IN and OUT Ranges: (various)
When a sequence is selected, the display shows the Bar, Beat and Clock at which the TS-12 will
enter and exit record when AUTOPUNCH=ON. Press the soft buttons nearest IN and OUT to
select the Edit Times parameters for editing.
The Edit Times are set using the Data Entry Slider or the Up/Down Arrow buttons. Repeatedly
pressing the soft button next to either time toggles the cursor between the Bar, Beat and Clock
value.
RESET
Pressing this soft button resets the currently selected time to its default value (the beginning and
end of the sequence or song). IN is reset to 001.01.00, or the beginning of the sequence, and OUT
is reset to the time value for the last clock of the sequence. If other values are installed, they will
remain in effect until they are reset or a different sequence or song is selected.
SET
This sets the selected time to the current sequencer time value (as shown on the Locate page) if
the sequencer is running. If the sequencer is stopped, the most recent time value is used. Using
the Locate function does affect the current time value.
Edit Times in Song Mode
You can use the Autopunch mode and Edit Times to punch in and out on the song tracks as well
as sequence tracks. When a song is selected, pressing Locate twice shows the following:
Bar Beat Clock
. . . .
Step Rep
Bar Beat ClockStep Rep
. . . .
Notice that two more parameters are added to the Edit In and Out Times: the Song Step number
and the Repetition of that step are added to the Bar, Beat and Clock within the sequence that
plays during the step. You can set the IN or OUT time to any point within the song.
Setting the Edit Times in Real Time
If you know the exact bar, beat and clock (or step, rep, bar, beat and clock in song mode) at which
you want to punch in and out, you can simply select and set the Edit Times using the data entry
controls. If not, you can set them “on the fly” using the following procedure:
• Press the soft button above IN to select the IN Edit Time.
• Press Play to begin playing the sequence or song.
• When the sequence or song reaches the point where you want to punch in, press SET. This
installs that time as the IN Edit Time and moves the underline to OUT.
• At the point where you want to punch out, press SET again. This installs that time as the OUT
Edit Time and moves the underline back to IN.
• Now, assuming Autopunch is on, you can go into record and play along with the track, and
the TS-12 will automatically enter and exit record at those points which you chose.
To Next Page
Loading...
Need help?
General
