3 Copy
126
Copy
3
[Build Job - Chapter Start] Screen
This screen allows you to set the chapter start.
1 Select any option.
îš„Off
The next stack of documents is copied after the previous stack.
îš„On
The next stack of documents is copied from Side 1 of a new sheet of paper.
îš„Pages per Side - New Page
When [Pages per Side] is set, even if all documents are divided for every chapter
before all of them are assembled in the Pages per Side feature, the next stack of
document is copied from Side 2 of the paper.
[Segment Separators] Screen
This screen allows you to insert a sheet of paper as a separator in between each stack
of documents. You can specify the number of separators to insert in the range from 1
to 99 as necessary.
Note • You can specify different settings for each stack of documents. If you do not specify
particular settings for each stack of documents, the previously specified settings are applied.
1 Select any option.
îš„No Separators
Does not insert any separators.
îš„Blank Separators
Inserts blank separators.
If you select this option, load documents, and press the <Start> button, the blank
separators are inserted before the copies of the documents.
îš„1 Sided Side 1 Only
A first page of the loaded documents is copied on the front side of a separator, and the
rest of the pages are copied on the paper other than a separator.
When [Pages per Side] is set, the number of pages (2 pages, 4 pages, or 8 pages) that
you selected to copy onto one side of a single sheet, starting from the first page of the
loaded documents, are copied onto the front page of a separator.
When you load a single sheet document, the document is copied onto a separator.
To Next Page
Loading...
Need help?
General
