Copying Procedure
51
Copy
3
1 Remove any paper clips and staples before
loading a document.
2 Adjust the document guides to match the
size of the document loaded.
Note • When loading a large size document such
as A3, lift up the document feeder tray,
and open the document stopper
rightward.
3 Load the document face up (when the
document is 2-sided, load the front side up)
in the center of the document feeder.
Note • The Confirmation indicator lights up when
the document is loaded correctly.
• When the documents is loaded in the
document feeder, the document feeder
tray lifts up. You can set the timing of the
lift. For more information, refer to "5
Tools" > "Common Service Settings" >
"Other Settings" > "Document Feeder
Tray Elevation" in the Administrator
Guide.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with
sizes from 15 x 15 mm to 297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard
size documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard
document size, refer to "Original Size (Specifying the Scan Size for the Document)" (P.81).
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the
System Administration mode. For information on the paper size settings, refer to "5 Tools" > "Common
Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
1 Open the document cover.
Important • Make sure that the touch screen is active,
and then load a document. Otherwise, the
machine may not properly detect the
document size.
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
Document stopper
Confirmation indicator
To Next Page
Loading...
Need help?
General
