Power Source
35
Product Overview
2
Power Source
The machine is provided with the power switch and the main power switch.
Main power switch
Press the main power switch to the [ ] position.
The <Main Power> indicator goes out on the right
side of the control panel, and the machine powers
off.
Power switch
To use the machine, press the power switch to
the [ | ] position to switch its power on. You can
start operations after the machine warms up.
Switching the Main Power On
The following describes how to switch the main power on.
Important • Do not switch off the main power immediately after switching on the main power. This may
damage the hard disk and the memory or cause a machine malfunction.
1 Make sure that the power cord is plugged in correctly.
2 Open the front cover.
3 Press the main power switch to the [ | ] position
to switch the main power on.
The <Main Power> indicator lights up on the
control panel.
4 Close the front cover.
Switching the Power On
The following describes how to switch the power on.
When using D125 or D110, the machine takes approximately 5 minutes to warm up and
to be ready to copy or print after switching the power on. This may take more time
depending on your machine configuration.
When using D95, the machine takes approximately 6 minutes to warm up and to be
ready to copy or print after switching the power on. This may take more time depending
on your machine configuration.
Powerswitch
Mainpowerswitch
To Next Page
Loading...
Need help?
General
