3 Copy
54
Copy
3
Step 3 Entering a Quantity
The following describes how to enter the number of copy sets. You can enter up to
9999 sets.
1 Enter the number of copies using the numeric
keypad.
The number of copies entered appears on the
upper right of the touch screen.
2 If you have entered an incorrect value, press the
<C (Clear)> button and then enter the correct
value.
Step 4 Starting the Copy Job
The following describes how to start a copy job.
1 Press the <Start> button.
Important • If the document has been loaded in the
document feeder, do not hold down the
document while it is being conveyed.
• Copies cannot be made if a copy protection
code is detected. For information on copy
protection codes, refer to "Secure Watermark
(Managing Document Security)" (P.109).
îš„If you have more documents
If you have more documents to copy, select [Next
Original] on the touch screen while the current
document is being scanned. This allows you to scan the documents as a single set of
data.
2 Select [Next Original] while scanning is in
progress.
Note • When using the document feeder, load
the next document after the machine has
finished scanning the first document.
• When [Next Original] is displayed on the
screen shown on the right and no
operation is performed for a certain period
of time, the machine automatically
assumes that there are no more documents.
• You can change the number of copies by selecting [Change Quantity] that is displayed after
selecting [Delete].
Numeric keypad
<C (Clear)> button
<Start> button
To Next Page
Loading...
Need help?
General
