Example:
Outside of the document may have been scanned because the scanned document is shorter than the specified
paper size. Take one of the following measures, and then scan again.
● Load a document of the specified paper size in the ADF paper chute (feeder).
● Change the scan settings so that the scanning area is set inside of the document.
ATTENTION
Ways to designate the scanning area differ depending on image scanning applications. For details, refer to
the help for the image scanning application.
Invalid Command
The command was ended abnormally.
There may be a problem with the USB cable connection.
● Make sure that the USB cable is connected properly.
● Turn the scanner off then back on.
If the problem persists, write down the error code and contact the distributor/dealer where you purchased this
product. Or, make an inquiry by referring to the contact information at the Contact for Inquiries section in
Safety Precautions bundled with this product.
Troubleshooting
157
To Next Page
Loading...
Need help?
General
